External Interface; Usb Memory Interface - NF DP015S Instruction Manual

10.27 External Interface

This is the interface to control the product from an external computer. The RS232 and USB
interfaces are provided by default. The command language is compliant with the SCPI Specification
Version 1999.0. (Factory default is USB)
USB interface (USB1.1, USBTMC)
Item
ID
Terminator
Note: The use of USB hub may cause a communication failure. It is recommended to use a
fully-shielded, short cable.
RS232 interface
Item
Terminal
Baud rate
Terminator
Parity
Stop bit
Data bit
Flow control
Note: Binary transmission is not supported.
Note: Use a cross cable.
GPIB interface (optional, IEEE488.1 std 1987 compliant)
Item
Address
Terminator
Note: Binary transmission is not supported.
Note: Query for the main unit status byte using a serial poll is not supported.

10.28 USB Memory Interface

Commercial USB memory sticks can be used.
Available memory
Connector
Format
Writable/readable
contents
File operation
Note: The time stamp recorded on a file is different from the actual date and time.
We do not guarantee that all USB memories can be operational with this product.
DP Series
Already assigned for each device
"LF"
Description or Selection
D-sub 9-pin (male)
9600 / 19200
"CR""LF" / "CR" / "LF"
None/Odd/Even
1 / 2
7 / 8
None/Hardware/Software
Description or Selection
0 to 30
"LF"
USB 1.1 or USB 2.0-compliant product
USB-A (front panel)
FAT32
Basic Setting Memory, Sequence, Simulation, arbitrary wave
Create dedicated directory, rename, load, and save
2-byte characters (Japanese, etc.) are not supported,
10.27 External Interface
Description
9600 bps
"CR" "LF"
None
1 bit
8 bit
None
2
Description
Factory default
Factory default
267