Simulation (Optional) - NF DP015S Instruction Manual

10. Specifications

10.19 Simulation (Optional)

This allows you to simulate power line abnormalities, such as blackout, voltage rise, voltage drop,
abrupt phase change, and abrupt frequency change. It can be used only for AC, sine wave, and
AC+DC-INT. Note that it does not support IEC or other standard test. In the polyphase model,
polyphase system, and polyphase output of the Multi-phase model, only the balanced mode is
available.
Number of memories
Number of steps
Setting range of Step
Time
Parameter
Simulation control
260
5 (non-volatile)
6 (Initial, Normal 1, Trans 1, Abnormal, Trans 2, Normal 2)
0.0010 s to 999.9999 s (0 s is available only for the Transition Step)
Output range
(The above item is common within the Simulation)
AC voltage
Frequency
Waveform (sine wave only)
Start Phase (excluding the Transition Step)
Stop Phase (excluding the Transition Step)
Synchronous step output (2bit)
Trigger output
Repeat count (1 to 9999 times or infinite)
Initial
Normal1
初期 定常1
Trigger setting example
トリガ設定例
Step sync 1 output example
ステップ同期1出力例
Step sync 2 output example
ステップ同期2出力例
Start
Stop
All models
Trans1 Abnormal Trans2
移行1 異常
PROGRAMMABLE AC POWER SOURCE
Initial
Normal2
移行2 定常2 初期