Sequence (Optional) - NF DP015S Instruction Manual

10.18 Sequence (Optional)

Effective only for AC-INT, AC+DC-INT, and DC-INT.
Number of memories
Number of steps
Setting range of Step
Time
Intra-Step behavior
Parameter
Sequence control
Note: For DC-INT, the AC phase voltage, frequency, waveform, Start Phase, and Stop Phase
cannot be set.
Note: The phase angle can be set only for the polyphase model, polyphase system, and polyphase
output of the Multi-phase model. The Start Phase and Stop Phase are specified for the L1
phase, and the component of the phase angle setting is added to them for the other phases.
DP Series
5 (non-volatile)
Maximum 255 (for each sequence)
0.0010 s to 999.9999 s
Constant, Keep, Linear Sweep
Output range
AC/DC mode (The signal source is fixed to INT)
(The above 2 items are common within one sequence)
AC phase voltage, frequency, waveform
DC voltage
Start Phase
Stop Phase
Phase angle
Step termination
Jump count (1 to 9999, or infinite)
Specification of the Jump-to step
Synchronous step output (2bit)
Specification of the branch step
Trigger output
Start
Stop
Hold
Resume
Branch 1, Branch 2
10.18 Sequence (Optional)
All models
259