Ac/Dc Mode - NF DP015S Instruction Manual

10.3

AC/DC Mode

AC/DC mode
AC
AC+DC
DC
DP Series
Single-phase model, Multi-phase
model
AC, AC+DC, DC
The signal source and amplification section of this product are AC-coupled,
and the DC component is canceled.
Only the AC output setting of 40 Hz or higher is available.
The signal sources that can be combined are INT, VCA, SYNC, EXT, and
ADD.
When the waveform superimposed with DC is amplified using optional EXT
and ADD (using external signal sources), it may not be an intended output
because the DC component is canceled. In this case, select the AC+DC mode.
The signal source and amplification section of this product are DC-coupled,
and the DC component is also amplified.
The AC and DC output settings of 1 Hz or higher are available.
The signal sources that can be combined are INT, SYNC, EXT, and ADD.
In the polyphase model, polyphase system, and polyphase output of the
Multi-phase model, only the AC setting is available.
Fixed to this mode in the Simulation.
Select this mode when you want to amplify a signal including DC, to
superimpose DC (DC offset), or output a frequency of 40 Hz or lower. Also
select this mode when the DC component temporally occurs, for example, by
sudden change of voltage or phase.
The signal source and amplification section of this product are DC-coupled.
Only the DC setting is available.
The signal sources that can be combined are INT and VCA.
It is unavailable for the polyphase model, the polyphase system, and polyphase
output of the Multi-phase model.
Polyphase model, Polyphase system
AC, AC+DC
Description
10.3 AC/DC Mode
243