Sequence Memory; Table 4-9 Content Saved In Sequence Memory - NF DP015S Instruction Manual

-------- Notes----------------------------------------------------------------------------------------------------------------
 A file cannot be renamed in the USB memory if a file with the same name exists in the
NF_TOOL\NF_DP\ARB_DATA folder. An error message is displayed.
---------------------------------------------------------------------------------------------------------------------------------

4.8.3 Sequence Memory

The user-created sequence can be saved into the Sequence Memory.
Both the internal and USB memories can be selected as the Sequence Memory. Creation and saving
of a sequence are performed using the sequence menu (see 4.2) or the control software in the
attached CD-ROM. For the content saved in the Sequence Memory, see Table 4-9.
The internal memory has 5 Sequence Memories from No. 1 to No. 5.
Setting Item
Output range selection
Output mode selection
Parameters of Sequence Function
 SEQ Store
In the Memory View, select [SEQ Store] to change to the Sequence Save View as below, allowing
you to save, clear, and rename the sequence. For the operation method, see 4.2.8 and 4.2.9.
DP Series

Table 4-9 Content Saved in Sequence Memory

Factory default setting
100V
AC-INT
Refer to 4.28
4.8 Using Memory Function
151