Installing The Lamp - Christie CP2308-C Installation And Setup Manual

7. Lock the lens assembly in place with a hex key.
8. Replace the lens surround.

Installing the lamp

Complete the following procedure to install the lamp.
Warning! Failure to comply with the following could result in death or serious injury.
• This procedure must be performed by Christie qualified technicians.
• EXPLOSION HAZARD! Always wear manufacturer approved protective safety clothing (gloves,
jacket, face shield) whenever the lamp door is open or when handling the lamp. Any local or
federal specifications take precedence over Christie's protective clothing recommendations.
• Do not open the lamp door while the lamp is on.
• EXPLOSION HAZARD! Allow sufficient time for the lamp to cool down before powering down the
product, disconnecting it from AC, and opening the lamp door.
• EXPLOSION HAZARD! Do not stress the glass of a lamp or bare bulb in any way.
• EXPLOSION HAZARD! Lamps and bare bulbs, even when packaged, may explode if dropped or
mishandled.
Caution! Failure to comply with the following could result in minor or moderate injury.
• Improper installation of the lamp can damage the projector.
• Incorrect lamp power supply and igniter connections can damage the product.
1. If the projector is operating, turn it off and allow it to cool a minimum of 15 minutes.
2. Turn the breaker switch for the projector off.
3. Disconnect the projector from AC power.
4. Disconnect the touch panel communication cable from the rear of the projector.
5. Remove the touch panel from the rear of the projector.
6. Put on your protective clothing, face shield, and gloves.
7. Insert the key in the lamp door lock, turn the key, and then open the lamp door.
8. Loosen the two thumbscrews and open the firewall door.
CP2308-C Installation and Setup Manual
020-102492-01 Rev. 1 (01-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Installation and setup
17