Administration
Syslog
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Related Commands
Command
show logging
logging aggregation enable
Use this command to enable the switch to consolidate consecutive log messages
of the same type into a single log message. Use the no form of the command to
disable this feature.
logging aggregation enable
no logging aggregation enable
Default
Logging aggregation is disabled.
Command Modes
Global Config
Related Commands
Command
logging
aggregation
maxtime
show logging
logging aggregation maxtime
Use this command to set the logging aggregation time period. Use the no form to
reset the time period to the default value (15 sec). If two or more of the same log
message are generated consecutively within the configured time interval, and no
event occurs in between, then the messages are aggregated into a single log
message. The range is 15 seconds to 120 seconds.
logging aggregation maxtime 15-120
no logging aggregation enable
Description
Displays logging configuration information.
Description
Sets the logging aggregation time period.
Displays logging configuration information.
2
137