®
Invacare
- Kite
8.7.2
Replacing the front bulb holder (LED lighting unit)
Requirements:
· Jaw spanner 7 mm
· Allen key 3 mm
· TX25 torx screwdriver
· oblique pliers
· cable binder
·
Loosen the nut (2) with a 7 mm jaw spanner and a 3 mm Allen key and remove.
·
Remove the front headlight (1) from the lamp holder (3) and place it carefully to the side.
·
Undo and remove the two screws (4) with a TX25 torx screwdriver.
·
Replace the lamp holder (3).
·
Reassembly takes place in the reverse order.
·
To complete, check all vehicle functions.
SERVICE MANUAL
51