Replacing The Front Bulb Holder (Led Lighting Unit) - Invacare Storm4 Max Service Manual

® 4
Invacare - STORM
7.2.3

Replacing the front bulb holder (LED lighting unit)

Requirements:
 4 mm Allen key
 8 mm spanner
Dismantling the bulbholder:

Loosen the Allen screw (1) using a 4 mm Allen key and remove the headlight from the
mounting.

Loosen the two cap nuts (2) using an 8 mm spanner and remove the headlight with the
mounting from the rubber bumpers.

Replace the mounting.
Refitting the bulbholder:

Refit the parts in reverse order.

Now tighten all the screws finger-tight again.

Check all vehicle functions.

Adjust the headlight roughly using the grid. The user can carry out the final adjustment
following the operating manual.
MAX SERVICE MANUAL
41