Table of Contents
Advertisement
12.1.1 Repairing a flat tyre (pneumatic tyres type 200 x 50)
Requirements:
• Allen key 5 mm
• 2 x Open-end spanners 13 mm
• Repair kit for inner tubes or an new inner tube.
• Talcum powder
Remove the wheel
• Jack the vehicle up and place a block of wood underneath it
to prop it up.
• Remove the black end-caps from the bolt and the nut (if
applicable).
• Remove the nut from the bolt using the open-end spanners
(1).
• Remove the axle and the wheel from the fork.
NOTE
Re-assembly is done in reverse order. Make sure that the wheel is put back on the same side it
was on, and that it runs in the same direction it did before it was removed.
84
Advertisement
Table of Contents
