Water Pump Installation; Flywheel, Clutch Disc, And Clutch Cover (Mt) Installation; Drive Plate (At) Installation - Mazda B-Series 1997 Workshop Manual

ASSEMBLY
Water pump
1.
Position the gasket on the water pump (use contact
cement).
2. Install the water purnpon the cylinder blockand tighten the
bolts to the specified torque. Apply sealant to bolts prior to
installation.
Tightening torque:
20-30 N.m (2.0-3.0 kgfam, 15--22 ftdbf)
Flywheel, clutch disc, and clutch cover (MT)
1. Install the flywheel.
Tightening torque:
73-87 N
-
m (7.5-8.8 kgf
.
m, 54-64 ft
.
Ibf}
2. Install the clutch disc.
3. Clean the clutch cover and flywheel surfaces with suitable
commercial alcohol base solvent so ,that the surfaces are
free from any oil film.
Note
Do not use cleaners with a petroleum base. Do not
immerse the clutch cover in solvent.
4.
Position the clutch disc on flywheel so Clutch Aligner
T74P-7137-K, or equivalent can enter clutch pilot bearing
and align disc.
5. When installing original clutch cover, align clutch cover
and flywheel with rnarks made during removal.
6. Position the clutch cover on flywheel. Align the clutch
cover and disc.
Tightening torque:
21-32 N.m (2.0-3.3 kgfam, 15--24 ft-lbf)
7. Remove the clutch disc pilot tool.
Drive plate
(AT)
Install the drive plate and the reinforcement plate.
Tightening torque:
7 3 - 8 7 N.m {7.4-8.8 kgfem, 5 4 - 4 4 ft-lbf}