ASSEMBLY
VALVE SEAL PROTECTOR
(PLASTIC INSTALLATION CAP)
SUPPLIED WITH VALVE SEALS
w
VALVE
(0 28-0 30 INCH)
7 0 - 7 5 M M
4
'
Assembly Note
Valve seals
1. Put valve seal protector (plastic installation cap supplied
with valve seals) over end of valve.
2. Start valve seal carefully over valve seal protector. Push
valve seal down until jacket touches top of valve guide.
3. Remove valve seal protector.
4. Use SST to seat valve seal on valve guide.
Valve spring assembly
1. Install the valve spring and install retainer by compressing
valve with SST.