Oil Pump - Installation Note; Oil Pump Strainer And Tube Removal/Installation - Mazda B-Series 1997 Workshop Manual

OIL PUMP, OIL PUMP STRAINER AND TUBE
lnstallation Note
Oil pump
1. If the original oil pump is to be reused, install new oil pump
O-ring seals on the oil pump.
Note
Inspect and clean oil pump hole in the cylinder
block before installing the oil pump.
1 2. Prime the oil pump with 236 ml(8 ounces) of fresh engine
I
oil.
3. Install a new oil pump gasket and the oil pump.
Tightening torque:
10-1 4 N-m (1 02-1 43 kgf.cm, 89-1 24 ft-lbf)
lnstallation Note
Camshaft position sensor
Tightening torque:
d -
OIL PUMP STRAINER AND TUBE
REMOVAL I INSTALLATION
1.
Remove the engine. (Refer to Section €31 .)
2. Remove the oil pan.
3.
Remove strainer and tube, referring to Removal Note.
4.
Install in the reverse order of rernoval, referring to lnstallation Note.
Removal Note
Oil pump strainer and tube
1. Remove nut and two screws.
2.
Remove strainer and tube.
lnstallation Note
Oil pump strainer and tube
1. Thoroughly clean strainer and tube.
2. Clean all mounting surfaces.
3. Install two screws and nut.
Tightening torque:
Screws: 20-30 N-m (2.0-3.0 kgf.m, 14-22 ft-lbf)
Nut: 40-55 N.m (4.1-5.5 kgf.m, 3 0 - 4 1 ftelbf}