Intake Air System Components Removal/Inspectioninstallation (3.0L) - Mazda B-Series 1997 Workshop Manual

F2
INTAKE AIR SYSTEM
INTAKE AIR SYSTEM
PREPARATION
SST
49 UNO1 052
Spring lock
coupling
tool
(%
in)
I
For
fuel supply
line removal
49 UNO1 051
Spring lock
coupling
tool
(%
in)
For
fuel return
line removal
COMPONENTS
Removal / Inspection / lnstallation
1.
Disconnect intake air temperature sensor, mass air flow sensor, throttle position sensor and idle
speed control solenoid connectors.
2. Disconnect accelerator cable. (Refer to page F2-7.)
3. Remove in the order shown in the figure, referring to Removal Note.
4. Inspect all parts and repair or replace as necessary.
5. Install in the reverse order of removal, referring to lnstallation Note.
I
I
MF9610-B
7BUOF2-001
1.
Air intake hose
5. Intake manifold (not shown)
Inspect for damage Removal Note . . . . . . . . . . . . page F2-3
2. Air cleaner housing Installation Note . . . . . . . . . . page F2-4
3. Ignition coil and bracket assembly 6. Idle air control solenoid
4. Upper intake rnanifoldlthrottle body assembly
7. Tube
. . . . . . . . . . . . Removal Note page F2-3
. . . . . . . . . . . . . . . . Inspection page F2-6
. . . . . . . . . .
Installation Note page F2-5