Engine Assembly - Preparation - Mazda B-Series 1997 Workshop Manual

INSPECTION 1 REPAIR, ASSEMBLY
B1
PRESSURE PLATE
/
DOWEL
HEIGHT
BOLT HEIGHT
I
I
'IN
\
/
FLYWHEEL
\
I
\
CRANKSHAFT GEAR
I
Note
Dimension "A" is the minimum acceptable dimen-
sion from the crankshaft mounting surface to the
new resurfaced clutch facesurface. Dimension "B"
is the referenced minimum acceptable dimension
for the overall width of the outer edge.
3. Mount the flywheel rigidly on the crankshaft mounting
flange.
Surface runout: 0.13mm (0.005 in) TIR
Surface finish:
4.011.3 micrometer (1 60152 microinch)
4. The major diameter of dowel pin (press-fit diameter) must
not extend above the new surface.
5.The clutch cover retaining bolts must screw into the
flywheel under hand torque to within 1.52mm (0.06 in} of
new surface.
6. Flywheels with dimensions less than the charted dimen-
sions must not be used; install a new flywheel.
ASSEMBLY
PREPARATION
SST
I
49
068
Front cover
al~gnment tool
--
For
installation
of front
cover
1. Clean all parts before assembly.
2. Apply clean engine oil to all sliding and rotating parts.
3. Tighten all bolts and nuts to the specified torque.
49 UNOl 135
Valve spring
compressor
Caution
Do not reuse gaskets or oil seals.
For
collapsing
valve
spring
49
UNOl
070
2.3L crankshaft
@
&
@j
seal installer
For
installation of
rear main
oil seal