1-C-14. Installing Water Pump - Mazda 1975 Rotary Pickup Workshop Manual

1
C
t f l c
s h a f t
- P u l l e y b o s s
- E c c e n t r i c s h a f t p u l l e y
E c c e n t r r c s h a f t p u l l e y ( f o r c o m p r e s s o r )
Fig. 1-84
Eccentric shaft pulley and pulley bolt
I J t E .
.' .,': tightening the pulley bolt, be careful
not to
: :he washer from the bolt.
' - C- 1 3 .
I n s ta l li n g O il S t r ain er an d O il p an
Turn the engine on the work stand so that the
::om of the engine is up.
- ['ur off the excess gasket on the front cover along
' .' mounting
surface of the oil pan.
5. Place the gasket and oil pan in position.
6. Insert the bolts through the stiffeners, and tighten
the bolts little by little in turn until the torque
becomes 0.85 m-kg (6.1 ft-lb) evenly.
1-C-14. Installing Water Pump
I " Turn the engine on the work stand so that the
top of the engine is up.
2. Place the gaskets and water pump on the front
housing, and tighten the attaching nuts evenly to 2.7 5
m-kg (20 ft-lb) in the sequence shown in Fig. l-99.
Fig. 1-88 Installing water pump
Fig. 1-89
Tightening order of water pump
3. Install the eccentric
to the pulley boss.
shaft pulley (for compressor)
i
Place the oil strainer
: : ' n t h o u s i n g a n d t i g h t e n
gasket and strianer on the
the attaching bolts.
Fig. 1-86 Installing oil
.
\pply the sealing agent onto
. : i r o u s i n g .
strainer
the joint surfaces of
Fig. 1-87
Applying
sealing agent
Fig. 1-85 Cutting off excess gasket