ELECTRICAL SYSTEM COMPONENTS
K
OVERDRIVE DRUM SPEED (ODs) SENSOR
5R55E
ONLY
lnspection
1. Disconnect the ODs sensor connector.
2.
Measure resistance between the two ODS sensor termi-
nals.
Resistance: 305--735 ohms
3.
If not specified, replace the ODs sensor.
Replacement
1. Disconnect vehicle harness connector.
2. Remove attaching bolt with T30 Torx socket.
3. Remove ODs sensor from case.
4.
lnspect O-ring for damage.
5. Lubricate sensor O-ring with petroleum jelly.
6. Install ODs sensor into case and tighten attaching bolt.
Tightening torques:
8-11
N.m (82-112
kgf.cm, 6 1 - 8 7 inlbf)
7.
Reconnect vehicle harness.
OUTPUT SHAFT SPEED (OSS) SENSOR
5R55E ONLY
lnspection
1. Disconnect the OSS sensor connector.
2. Measure resistance between the two OSS sensor termi-
nals.
Resistance: 305-735
ohms
3. If not as specified, replace the OSS sensor.
Replacement
1.
Disconnect vehicle harness connector.
2.
Remove attaching bolt with T30 Torx socket.
3.
Remove OSS sensor from case.
4.
lnspect O-ring for damage.
5. Lubricate sensor O-ring with petroleum jelly.
6. Install OSS sensor into case and tighten attaching bolt.
Tightening torques:
8-11
N.m (82-112
kgf.cm, 6 1 - 8 7 in-lbf)
7.
Reconnect vehicle harness.