Secondary Shaft Parts Assembly - Mazda B-Series 1997 Workshop Manual

J1
TRANSMISSION
Secondary Shaft Parts
Assemble
in
the order shown in the figure, referring to Assembly Note.
FLANGE-OUTPUT
MJ1104-A
1.2nd gear needle bearing
2.2nd gear
3. Synchronizer ring (2nd)
4. Clutch hub and sleeve assembly ( I stf2nd)
5. Synchronizer ring (1 st)
6. 1st gear needle bearing
7.1 st gear
8. 1 st gear sleeve
9. Center bearing-inner
4BUOJ1-043
10. Center bearing-outer race
11.3rd gear needle bearing
12.3rd gear
13. Synchronizer ring (3rd)
14. Clutch hub and sleeve assembly (3rdl4th)
15. Spacer
16. Needle bearing
17. Retaining ring
18. Roller bearing
SLEEVE
BEARING C
REPLACER
T53T-4621-
Assembly Note
Secondary shaft
Press the 1st and 2nd gear components into position
using the SSTs and Bearing Cone Replacer T53T-
4621 -B, or equivalent.
I
MJ1105-B
Note
When installing the clutch hub and sleeve (Istl
2nd), make sure that the smaller width of the sleeve
faces the 2nd gear side. The reference marks face
the rear of the transmission.
Center bearing
Press the center bearing onto the secondary shaft using
the SSTs and sleeve.
2ND
-
1ST