Electronic Shift Transfer Case Disassembly - Mazda B-Series 1997 Workshop Manual

ELECTRONIC SHIFT TRANSFER CASE
J2
DISASSEMBLY
--
Precaution
General notes:
1.
Disassemble the transfer case in a clean area to prevent entry of dirt into the mechariisms.
2. Use only plastic hammers when applying force to separate the light alloy case joints.
3. Several parts look alike; organize them so they do not get mixed up.
Cleaning notes:
1.
Clean the transfer case exterior thoroughly with asteam cleaner of cleaning solvents beforedisassembly.
2.
Clean the removed parts with cleaning solvent, and dry with compressed air. Clean out all holes and
passages with compressed air, and verify that there are no obstructions.
Warning
Wear eye protection when using compressed air to clean components.
Transfer Case
1.
Drain the transfer case oil into a suitable container.
2.
Remove the brown wire from the motor connector, referring to Removal Note. (Refer to page
J2-42.)
3.
Disassemble in the order shown in the figure, referring to Disassembly Note.
4. Inspect all parts and repair or replace as necessary.