Table of Contents
Advertisement
ON-VEHICLE MAINTENANCE
Steps After Installation
1. Fill the cooling system with the specified amount and type of coolant.
2. Connect the negative battery cable.
3. Start the engine and check as follows:
(1)
Engine oil leakage
(2) Engine coolant leakage
4. Recheck the engine coolant and oil levels.
FRONT OIL SEAL
Replacement
1. Disconnect the negative battery cable.
2. Remove the drive belt.
3. Remove the crankshaft pulley, referring to Removal Note. (Refer to below.)
4. Remove the damper, referring to Removal Note. (Refer to below.)
5. Remove the front oil seal, referring to Removal Note. (Refer to below.)
6. Install in the reverse order of removal, referring to Installation Note.
0
FRONT
OF ENGINE
MB1118-A
4BUOB2-054
Removal note
Crankshaft pulley
1. Remove the pulley-to-damper bolts.
2. Remove the crankshaft pulley.
Damper
1. Remove the damper bolt and washer.
2. Remove the damper using Crankshaft Damper Remover
T58P-6316-D and Damper Remover Adapter T82L-
631 6-B, or equivalents.
Front oil seal
Pry the seal from the timing cover with a flat-bladed
screwdriver or other similar tool.
Note
Use care to prevent damage to the timing cover or
crankshaft.
4 ~ ~ 0 ~ 2 - 0 5 5
Advertisement
Table of Contents
Troubleshooting
