Crankshaft Position Sensor - Installation - Mazda B-Series 1997 Workshop Manual

ELECTRONIC IGNITION SYSTEM
G
4.0L
CRANKSHAFT
POSITION
SENSOR
(CKP)
CONNECTOR
Installation
2.3L
Note
Engine front cover design precisely locates crank-
shaft position sensor so no adjustment is required.
1. Position the crankshaft position sensor and install the
retaining bolt.
Tightening torque:
8-12 N-m (0.8-1.1 kgf-m, 6--8 ft.lbf)
2. Connect the harness connector.
3. Install the water outlet tube with a new O-ring and install
the bolts.
Tightening torque:
10.5 N.m (1 -1 kgfem, 8 ft-lbf}
4. Install the generator.
5.
Fill the cooling system.
3.0L 1 4.0L
1. Position the crankshaft position sensor on engine.
2. Install the two sensor screws.
Caution
Do not overtighten crankshaft position sensor
screws.
Tightening torques:
3.OL: 5-7 N-m (46-70 kgfecm, 4 0 - 4 1 in.lbf)
4.OL: 9-1 2 N-m (92-1 21 kgfecm, 75-1 06 inelbf)
3. Lower vehicle. (3.01- only).
4. Route the sensor harness and connect the harness
connector.
5. Connect the negative battery cable.