Table of Contents
Advertisement
TRANSMISSION
SHAFT ADAPTER
T75L-7025-M 14x4 ON1
Countershaft rear bearing
Temporarily ir~stall a suitable spacer (inner bore larger
than 21mm (0.82 in), outer bore smaller than 36mm
(1.41 in), 15-20mm
(0.59-0.78
in) overall length) in
place of the countershaft bearing.
4BUOJ1-065
Secondary shaft rear bearing
lnstall the bearing using the SST, Shaft Adapter T75L-
7025-M
(4x4
only), Gear Installing Spacer T88T-7025-E,
or equivalents.
4BUOJ1-066
Locknuts
Caution
Do not reuse the removed locknuts.
1. Remove the temporary spacer from the countershaft.
2. lnstall the countershaft rear bearing.
3. Lock the transmission into 1 st and 3rd gears.
4. lnstall the secondary shaft locknut.
Tightening torque:
21 6-274
N.m (22-27
kgf-m, 159-202
ft-lbf)
5. lnstall the countershaft locknut.
Tightening torque:
128-1 96 N.m { I 3.0-1 9.8 kgf-m, 94--144 ftelbf)
6. Stake the locknuts.
Oil passage
Install the oil passage.
Tightening torque::
8-10
N-m (0.8--1.0 kgf-m, 6-7
ftalbf]
Advertisement
Table of Contents
Troubleshooting
