Camshaft Installation (4.0L); Cylinder Head Assembly (4.0L) - Mazda B-Series 1997 Workshop Manual

ASSEMBLY
Camshaft
1. lnstall the camshaft into the cylinde~r block.
Caution
Do not scratch the camshaft bearings while install-
ing the camshaft.
2. lnstall the thrust plate and screws.
3. Tighten the thrust plate screws.
Tightening torque:
9-13 N.m (0.97-1.24 kgf-m, 7.-9 ft.lbf)
I I
4. Check camshaft end play as follows:
(1) Measure camshaft end play.
End play
0.065-0.165 mm (0.025-0.064 in)
CYLINDER HEAD
1. Assemble in the order shown in the figure, referring to Assembly Note.
2.
Install the rocker arm shaft assemblies and push rods, referring to Assembly Note. (Refer to page
B3-57.)
3. Install the lower intake manifold, referring to Assembly Note. (Refer to page B3.-11, Step 3.)
4. lnstall the cylinder head cover. gaskets and bolts, referring to Assembly Note. (Refer to page B3-17.)