Engine Oil Replacement; Oil Capacity; Fuel Filter Replacement - Mazda B-Series 1997 Workshop Manual

ENGINE OIL, OIL FILTER
?
DRAIN PLUG
REPLACEMENT
Warning
Be careful
when draining; the
oil
is hot.
1. Warm the engine to normal operating temperature and
stop it.
2.
Remove the oil filler cap and the oil pan drain plug.
3. Drain the oil into a suitable container.
4. Install a new gasket and the drain plug.
Tightening torque:
21-33 N-rn (2.0-3.3 kgf.m, 15-24 ftelbf)
5. Refill the engine with the specified type and amount of
engine oil.
Oil capacity
liters {US qt, Imp qt}
(with oil filter)
- -
6. Refit the oil filler cap.
7. Run the engine and check for leaks.
8. Check the oil level and add oil if necessary.
OIL FILTER
REPLACEMENT
1. Remove the oil filter.
2. Remove insert if necessary. The insert is not normally
removed for replacing filter.
3. Use a clean rag to wipe off the mouriting surface of the oil
filter.
4.Apply a small arnount of clean engine oil to the oil
gasket of the new filter.
5. Install insert.
Tightening torque:
28-35 N.m (2.8-3.5 kgf-m, 21-26 ft-lbf}
Note
Do not tighten with oil filter wrench as that will make
it difficult to remove.
6. Install the oil filter and tighten it by hand until the oil
gasket contacts the mounting base.
7. Start the engine and check for leaks.
8. Check the oil level and add if necessary.
Oil filter capacity: 0.9 liter (1.0 U!S qt.,
0.8
Imp qt)
5BUOD1-005