Recharging; Slow Charging; Quick Charging - Mazda B-Series 1997 Workshop Manual

CHARGING SYSTEM
1. Check the tightness of the terminals to ensure good
electrical connections.
Tightening torque:
6.8-10.0 N-m (0.69-1 .O1 kgf.m, 5-7 ftslbf)
2. Check for corroded and frayed battery cables. Clean or
replace as necessary.
3. Check the rubber protector on the positive terminal for
proper coverage.
4. Clean the terminals if necessary, and coat them with
grease.
Recharging
Caution
Do not perform quick charging for over 20 minutes
to prevent damaging the battery.
Place the battery i n water to prevent it from over-
heating.
Warm up the battery to 5°C (41
O F )
before charging.
Warning
Before performing maintenance or recharging the
battery, turn off all accessories and stop the en-
gine.
When disconnecting the battery, the negative cable
must be removed first and installed last.
Slow charging
If the battery has passed the load test, it can be recharged
in 2 hours at 20A. If a full state of charge is desired, the
charge can be completed by a low constant current of 3 to
5 amps for several hours.
4BUOGX-015
Quick charging
1 . Remove the battery from the vehicle to perform a quick
charge.
2. Charge the battery for 20 minutes at 35A.
4BUOGX-016