ELECTRONIC IGNITION SYSTEM
IGNITION COIL ASSEMBLIES
Removal l Installation
1. Disconnect the negative battery cable.
2. Remove in the order shown in the figure, referring to Removal Note.
3. Install in the reverse order of removal, referring to Installation Note.
.)I111
, :
11p
I
_ 1
MG1092-A
5BUOGX-027
1.
Ignition coil
Removal Note
........................ page
G-48
Installation Note .....................
page G-48
High-tension lead
I . Measure resistance of the high-tension leads.
Specifications: less than 22.9
kR
p. r 1 m (3.28 ft)
2. If not as specified, replace the high-tension lead set.