Thrust Washer; Reverse Idler Gear Installation - Mazda B-Series 1997 Workshop Manual

TRANSMISSION
Thrust washer
1.
While pushing the thrust washer against the shoulder on
the countershaft, measure the clearance between the
thrust washer and the countershaft reverse gear.
Clearance: 0.25--0.35mm (0.01 0-4.01 4 in)
2. If the clearance is not as specified, select the proper thrust
washer.
Thrust Washer Select Chart
I
I
MJ1127-A 5BUOJ1-007
Thickness
mm
{in)
1
I
I
MJlO91-B 5BUOJ1-008
End play: 0.1--0.2mm (0.0039-0.0078 in)
REVERSE RETAINING RING
IDLER GEAR DIAMETER
AFTER ASSEMBLY
5. If the end play is not as specified, select the proper
retaining ring.
Reverse idler gear
1. Install the thrust washer onto the reverse idler gear.
Note
Make sure the tabs on the thrust washer mates with
the groove on the reverse idler shaft.
2. Install the needle bearings, idler gear, and spacer.
3. Install the original retaining ring.
4.
Measure the end play between the retaining ring and the
reverse idler gear.
Reverse Idler Gear Retaining Ring Select Chart
Thickness mm
{in)
- - -
-
- - -
- - - - - -
I 5 {0.059}
- - - -
- - - -
1 6 (0.0629)
-
- -
- - - -
--
I 7 {0.0669}
- - - -
- -
-
- - -
- -
1.8 {0.0708}
- -
-
-
-
-
-
1.9 {0.0748}
MJ1129 A 4BUOJ1 064