OIL PRESSURE
OIL PRESSURE
PREPARATION
SST
I
I
I
4BUOD2-022
INSPECTION
0
1
1. Remove the oil pressure sensor.
49 01 87 280
I
For
MD1003-B
2. Screw the SST into the oil pressure sensor installation
1
hole.
Gauge,
oil pressure
3. Warm up the engine to normal operating temperature.
4. Run the engine at 2,500 rpm, and note the gauge read-
ings.
Oil pressure: 2 7 6 4 1 3 kPa (2.8-4.2 kgf/cm2,
40-40 psi)--2,500 rpm
5. If the pressure is not as specified, check for the cause and
repair as necessary. (Refer to Troubleshooting Guide.)
inspection of
oil pressure