Starter Disassembly/Assembly - Mazda B-Series 1997 Workshop Manual

G
STARTING SYSTEM
-
Disassembly / Assembly
1. Remove the positive brush connector from magnetic switch Terminal M.
2. Remove in the order shown in the figure, referring to Disassembly Note.
3. Inspect all parts and replace if necessary.
4.
Install in the reverse order of removal, referring to Assembly Note.
MG1056-C
1
5BUOGX-047
1. Magnetic switch
7. Lever and housing seal
Inspection ............................... page G-60
8.
Front cover
2. Rear cover
9. Stop ring and retainer
3. Brush holder assembly
10. Pinion and reduction gear
Disassembly Note .................. page G-59 Inspection ............................... page G-62
Assembly Note ....................... page G-59 Assembly Note ....................... page G-53
Inspection ............................... page G-61 11. E-ring
4. Armature 12. Internal gear
Inspection ............................... page G-61 Inspection ............................... page G-62
5. Planetary gears 13. Shaft
Inspection
...............................
page G-62 14. Spring
6. Starter frame