Cylinder Head Cover Reinforcement Plates And Cylinder Head Cover Gasket; Left Wire Harness Installation (4.0L) - Mazda B-Series 1997 Workshop Manual

ON-VEHICLE MAINTENANCE
2. If installing the right cylinder head cover, perform the following:
(1) lnstall a new cylinder head cover gasket, referring to lnstallation Note. (Refer to below.)
(2) lnstall the cylinder head co~ver, reinforcement plates and cylinder head covler bolts, referring to
lnstallation Note. (Refer to below.)
(3) Fasten the right wiring harness to the clip, referring to lnstallation Note. (Refer to page B3-18.)
(4) Connect the filler neck vacuum hose, referring to lnstallation Note. (Refer to page B3-18.)
(5) lnstall two wiring harnesses onto the right cylinder head cover.
(6) lnstall the ignition coil pack. (Refer to Section G.)
(7) lnstall the generator. (Refer to Section G.)
3. Install the high tension leads onto the cylinder head covers.
4. lnstall the air conditioning pipe bolt onto the upper intake manifold, if equipped.
5. lnstall the air intake hose, referring to lnstallation Note. (Refer to page B3-19.)
6. lnstall the accelerator cable shield, referring to lnstallation Note. (Refer to page B3-19.)
7. Connect the negative battery cable.
LOWER
CYLINDER INTAKE
CYLINDER
MANIFOLD
lnstallation Note
Cylinder head cover, reinforcement plates and
cylinder head cover gasket
Apply sealant to the seam between the lower intake
manifold and cylinder head and an 8mm (0.125 in) ball
to each bolt hole on the exhaust ~nanifold side of the
cylinder head cover as shown.
Cylinder head cover bolts
CYLINDER
BLOCK
Tightening torque:
6--8 N.m (0.62-0.81 kgf-m,
4.5;-5.9
ftslbf)
4BUOB3-033
Left wire harness
lnstall the wire harness and push down on the clip.