Cooling Fan And Clutch Removal/Installation (3.0L) - Mazda B-Series 1997 Workshop Manual

COOLING FAN AND CLUTCH
COOLING FAN AND CLUTCH
REMOVAL I INSTALLATION
1. Disconnect the negative battery cable.
2. Drain the engine coolant.
3. Remove in the order shown in the figure, referring to Removal Note.
4.
Install in the reverse order of removal, referring to Installation Note.
1. Cooling fan 2. Clutch
.................................
Removal Note below
.................... Installation Note page E2-16
Removal Note
Cooling fan
1.
Remove the two fan shroud attaching screws and lift the
fan shroud out of the two lower attaching clips.
2.
Remove the nut attaching the clutch to the water pump.
Caution
The nut which attaches the clutch to the water
pump shaft has a left-hand thread and must be
rotated clockwise for removal.