Engine Disassembly/Assembly - Mazda 2002 6 Workshop Manual

No.1 Engine Mount Bracket Installation Note
1. Tighten No.1 engine mount bracket bolt A.
Tightening torque:
93.1—116.6 N·m {9.50—11.88 kgf·m, 68.72—
85.92 ft·lbf}
2. Tighten No.1 engine mount bracket bolt B.
Tightening torque:
93.1—116.6 N·m {9.50—11.88 kgf·m, 68.72—
85.92 ft·lbf}
No.1 Engine Mount Rubber Installation Note
1. Tighten through bolt A on No.1 engine mount
bracket.
Tightening torque:
85.3—116.6 N·m {8.7—11.88 kgf·m, 62.93—
85.92 ft·lbf}
2. Tighten through bolt B on chassis side.
Tightening torque:
93.1—116.6 N·m {9.50—11.88 kgf·m, 68.72—
85.92 ft·lbf}
End Of Sie

ENGINE DISASSEMBLY/ASSEMBLY

1. Disconnect the engine and automatic transaxle. (ATX) (See
INSTALLATION.)
2. Disconnect the engine and manual transaxle. (MTX) (See
INSTALLATION.)
3. Remove the intake-air system. (See
4. Remove the exhaust system. (See
5. Remove the generator.
6. Remove the ignition coils. (See
7. Remove the CKP sensor. (See
8. Assemble in the reverse order of disassembly.
End Of Sie
ENGINE
F–10 INTAKE-AIR SYSTEM
F–35 EXHAUST SYSTEM
G–8 IGNITION COIL REMOVAL/INSTALLATION.)
F–54 CRANKSHAFT POSITION (CKP) SENSOR
K–29 AUTOMATIC TRANSAXLE REMOVAL/
J–5 MANUAL TRANSAXLE REMOVAL/
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
B
AME2213W008
AME2213W009
A6E222401001W02
B–31