Engine Tune-Up; Engine Tune-Up Preparation; Idle Speed Inspection; Correction Procedure - Mazda Mazda6 Workshop Manual Supplement

ENGINE TUNE-UP PREPARATION

1. Start the engine and warm up completely.
2. Verify that the gear is in neutral position.
3. Verify that the accelerator pedal is released.
4. Turn off the A/C switch.
5. Turn off all electrical loads.
6. Verify that no DTC is present.
7. Connect the WDS or equivalent to the DLC-2.
8. Wait until the electrical fan stops.
End Of Sie

IDLE SPEED INSPECTION

1. Perform "Engine Tune-up Preparation". (See
2. Monitor the RPM PID using the WDS or equivalent.
3. Verify that engine speed is within specification.
• If not as specified, inspect the following.
— Suction control valve
— Fuel injector
— Accelerator position sensor
— ECT sensor
— Fuel pressure sensor
— CMP sensor
— CKP sensor
Specification
Load condition
No load
A/C switch is on
End Of Sie

CORRECTION PROCEDURE

Note
• Perform each procedure by selecting the corresponding menu on the WDS screen. These procedures
appear when "Powertrain" in the "Toolbox tab" is selected.
Correction after Parts Installation
Note
• Perform this procedure after replacing the PCM and/or fuel injectors.
1. Perform "Engine Tune-up Preparation". (See
2. Perform "Correction after Parts Installation" using the WDS or equivalent.
F2–34

ENGINE TUNE-UP

ENGINE TUNE-UP
F2–34 ENGINE TUNE-UP
Engine speed (rpm)
725—825 (775±50)
725—825 (775±50)
F2–34 ENGINE TUNE-UP
DLC-2
PREPARATION.)
PREPARATION.)
A6E400802000201
A6E40702001
A6E400802000202
A6E400802000203