Figure 168. Ntp Client Configuration - Samsung WEC8500 Operation Manual

2600-00FK1RGA4 Ver.
[NTP Server Configuration]
The NTP server configuration is as follows:
1) Go to configure mode of CLI.
WEC8500# configure terminal
2) Configure a NTP server.

ntp server enable: Configures a NTP server.

no ntp server enable: Disables a NTP server.
[Checking NTP Configuration Status]
To check the status of a NTP client or server, enter the 'show ntp' command.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<NTP> menu in the sub-menus.
The NTP initial window is shown below.
The Enable/Disable of a NTP server can be performed using a radio box.
You can configure polling interval enable/disable of a NTP client and also configure the
polling interval during enabling. The range of polling interval is 3-14.
Click the <Add> or <Delete> button to add or delete a NTP proxy server. Click the <Add>
button to configure a specific 'Server IP' or 'Server DOMAIN NAME' that will be used by
a NTP proxy.
© SAMSUNG Electronics Co., Ltd.
3.0

Figure 168. NTP client configuration

CHAPTER 9. IP Application
page 321 of 496