Radio Resource Management (Rrm) - Samsung WEC8500 Operation Manual

2600-00FK1RGA4 Ver.
7.4

Radio Resource Management (RRM)

RRM performs automatic setup function for AP's channel and Tx Power. RRM is
functionally divided into Dynamic Channel Selection (DCS), Dynamic Power control
(DPC), and Coverage Hole Detection and Control (CHDC). The DCS automatically sets
the channels of the APs. The DPC DCS automatically sets the Tx Power of the AP.
The CHDC adjusts the Tx Power when Coverage Hole occurs.
7.4.1 RRM Configuration
Describes the settings for using the RRM function and the cluster configuration.
Configuration using CLI
To configure each function, execute the command as follows:
1) Go to configure  rrm configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# rrm
2) Configure RRM. The 'no' parameter is used to clear the configuration. DCS, DPC and
CHDC, which are functions of RRM, can run only is the RRM is enabled.
WEC8500/configure/rrm# enable
3) In the cluster environment, set the same RF Group Name to all the connected APCs.
A name must consist of up to 15 characters.
WEC8500/configure/rrm# rf-group-name [Name]
4) To check the configured information, use the 'show rrm config-summary' command.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Radio>  <802.11a/n> or <802.11b/g/n>  <RRM> menu in the sub-menus.
Enable or disable the RRM service at the top of the menu. The RRM can be set in either
802.11a/n screen or 802.11b/g/n screens.
© SAMSUNG Electronics Co., Ltd.
3.0
Figure 114. RRM configuration window
CHAPTER 7. WLAN Additional Services
page 236 of 496