Dhcp Proxy - Samsung WEC8500 Operation Manual

Access point controller

Hide thumbs Also See for WEC8500:

Table of Contents

2600-00FK1RGA4

DHCP Proxy

The procedure of changing to the DHCP proxy is as follows.

Configuration using CLI

The CLI configuring a DHCP proxy is located as a command under 'ip dhcp-proxy' in the

configure mode.

1) Go to configure mode of CLI.

WEC8500# configure terminal

2) Switch to the DHCP proxy.

WEC8500/configure#ip dhcp-proxy enable

3) To check the configured information, use the 'show ip dhcp-proxy' command.

4) Use the below command to check an IP address that is leased through the DHCP proxy.

WEC8500t#show ip dhcp proxy-lease

10.10.10.100

Configuration using Web UI

In the menu bar of <WEC Main window>, select <Configuration> and then select the

<DHCP>  <Proxy> menu in the sub-menus.

You can configure the Proxy mode of DHCP to relay/proxy. Change the radio box for

configuration in the DHCP PROXY MODE of Global Parameter item.

Figure 93. DHCP Proxy

| Lease Expiration time

00:1c:bf:c1:50:28

CHAPTER 5. WLAN Management

2012/08/31 12:00:24

page 198 of 496

Table of Contents