2600-00FK1RGA4
Ver.
4.2.5
AP Configuration
The management interface of APC must be configured for the connection
between APC and W-EP AP.
4.2.5.1 Configuring MAC address
Configuration using CLI
To configure AP information, execute the command as follows:
1) Go to configure AP configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# ap [ap profile name]
WEC8500/configure/ap ap_1#
If there exists the same AP when entering [ap profile name], you are guided to the
mode where operator can configure the AP. If there is no same AP, the new AP
information is created.
2) Register the MAC address of the AP.
profile mac [MAC_ADDRESS]
3) To check the information of a configured AP, use the 'show ap summary config'
command.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Access Points> menu in the sub-menus.
1) Click the <Add> button.
2) Set AP PROFILE NAME and MAC ADDRESS and click the <Apply> button.
© SAMSUNG Electronics Co., Ltd.
3.0
Figure 65. Adding Access Points
CHAPTER 4. AP Connection Management
page 149 of 496