2600-00FK1RGA4
Ver.
7.4.2
DPC Configuration
Describes the setting options of the DPC function which automatically sets the Tx Power of
the AP.
Configuration using CLI
1) Go to configure rrm configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# rrm
2) Go to the wireless section where you want to change the settings.
WEC8500/configure/rrm# 80211a
3) Set the DPC function. Enter the dpc setting mode and set it to 'enable'. Use the 'no'
parameter to disable the mode. The function operates only when the RRM is set to
Enable.
WEC8500/configure/rrm/80211a# dpc
WEC8500/configure/rrm/80211a/dpc# enable
4) Execute the following command to change the Received Signal Strength Indication
(RSSI) threshold. The default value is
-70 (dBm).
WEC8500/configure/rrm/80211a/dpc# rssi-threshold [value]
5) Execute the following command to change the execution interval. The default value is
600 (seconds).
WEC8500/configure/rrm/80211a/dpc# periodic-interval [value]
6) Execute the following command to change the Tx Power range which is automatically
set by DPC. The default minimum is 16 for 80211a and 12 for 80211b. The default
maximum is 20 for both 80211a and 80211b.
WEC8500/configure/rrm/80211a/dpc# txPower min [value] max [value]
7) Check the settings using the 'show rrm config-summary' command.
© SAMSUNG Electronics Co., Ltd.
3.0
CHAPTER 7. WLAN Additional Services
page 237 of 496