Unauthorized Ap/Terminal Detection And Blocking - Samsung WEC8500 Operation Manual

2600-00FK1RGA4 Ver.
8.2 Unauthorized AP/Terminal Detection and
Blocking
As the security function, the W-EP wireless LAN device provides the detection service for
an unauthorized (rogue) AP using the Wireless Intrusion Detection System (WIDS)/WIPS
function.
This function detects any AP that is illegally installed without an administrator's approval
and also any wireless terminals connected to the AP. If an authorized wireless terminal is
connected to an unauthorized AP, some information may be exposed or the wireless LAN
may be attacked in some ways. Therefore, it is important to manage the risk.
8.2.1 Enabling Detection Function
The procedure of enabling the unauthorized AP and terminal detection function is shown
below.
Configuration using CLI
1) Go to configure mode of CLI.
WEC8500# configure terminal
2) Enable the detection function.
WEC8500/configure# wids enable
3) To check the configured information, use the following command.

show wids current-config
© SAMSUNG Electronics Co., Ltd.
3.0
CHAPTER 8. Security
page 281 of 496