Country Code - Samsung WEC8500 Operation Manual

2600-00FK1RGA4 Ver.
6.4

Country Code

You can use a country code to restrict the number of channels that can be used in an AP and
the maximum transmission power of each channel.
Configuration using CLI
To configure the country code function, go to country mode first by executing the
following command.
APC# configure terminal
APC/configure# country
APC/configure/country#
[Global Country Code Configuration]
If you configure a global country code, the country code can be specified to all the
connected APs at the same time. The command is shown below.

set-global [COUNTRY_CODE] [VALUE]
Parameter
COUNTRY_CODE
VALUE
To check the configuration information, use the 'show country global-config' command.
[AP Country Code Configuration]
To configure a country code, execute the command as follows:

set-ap [AP_ID] [COUNTRY_CODE] [VALUE]
Parameter
AP_ID
COUNTRY_CODE
VALUE
To check the configuration information, use the 'show country ap-config [AP_ID]'
command.
© SAMSUNG Electronics Co., Ltd.
3.0
Country code to configure
Environment configuration (both/outdoor/indoor/none)
AP ID (range: 1-500)
Country code to configure
Environment configuration (both/outdoor/indoor/none)
CHAPTER 6. Wi-Fi Configuration
Description
Description
page 223 of 496