Option 82 Configuration - Samsung WEC8500 Operation Manual

2600-00FK1RGA4 Ver.
5.4.4

Option 82 Configuration

The APC uses the DHCP Option 82 to provide various services during IP allocation by
forwarding the information such as access control, QoS, or security policy, etc.
when a wireless terminal connected to an AP receives an IP address.
The Option 82 has two fields, i.e. remote ID and circuit ID. Enter the name of an interface
for which the APC constantly does relay/proxy in the circuit ID and enter a part of AP
information in the remote ID accordingly. One of the following three data can be used as
the remote id of Option 82.

ap-mac: 802.11 MAC data of the AP. The length is 12-byte (Default).

ap-mac-ssid: The character string of SSID is added to the data of AP-MAC. The length
is variable.

ap-mac-ssid: Ethernet MAC data of the AP. The length is 12-byte.
To configure Option 82 related functions, go to the interface mode by executing the
following command.
WEC8500# configure terminal
WEC8500/configure#interface vlan10
WEC8500/configure/interface vlan10#
Configuration using CLI
[Configuring Option 82]
Enables or disables the Option 82 function. Can be configured for each interface.

dhcp option-82 [MODE]
Parameter
MODE
[Configuring Remote ID]
The command is shown below.

dhcp option-82 remote-id [MODE]
Parameter
MODE
© SAMSUNG Electronics Co., Ltd.
3.0
Configures whether to use the Option 82 function (enable/disable).
Specifies one out of the following three data to the Option 82 remote-id.
- ap-mac: MAC address of an AP
- ap-mac-ssid: MAC address and SSID of an AP
- ap- ethermac: Ethernet MAC address of an AP
CHAPTER 5. WLAN Management
Description
Description
page 199 of 496