Samsung WEC8500 Operation Manual page 290

2600-00FK1RGA4 Ver.
8.2.2.5 Unauthorized AP detection option
Operator can enable or disable the AP detection option pre-defined in the system.
Configuration using CLI
1) Go to configure  wids  rogue  ap configuration mode.
WEC8500# configure terminal
WEC8500/configure# wids
WEC8500/configure/wids# rogue
WEC8500/configure/wids/rogue# ap
WEC8500/configure/wids/rogue/ap#
2) Using the following command, configure the unauthorized AP detection option.

[OPTION] [NOTI_TYPE]
Parameter
OPTION
NOTI_TYPE
The description of OPTION parameter is as follows:
Parameter
ap-blacklist-check
managed_ssid_invalid_security
fakeap/beacon-on-invalid-
channel-detection
fakeap/beacon-without-ssid-
detection
fakeap/ managed-ssid-detection
illegal-channel-detection
managedap/ invalid-ssid-detection
unknownap/managed-ssid-
© SAMSUNG Electronics Co., Ltd.
3.0
Unauthorized AP detection option
Event save option
- Alarm: Notify the state with alarm
- Log: Save the state with sys log
Allocates Rogue ID = 101 by checking a rogue included in the
black list.
Allocates Rogue ID = 102 for an AP that uses a managed
SSID and its managed client is in the association status.
Allocates rogue ID = 103 for an AP whose UIC is invalid and
that uses a SSID that is not in the ssid white list among the
APs that use a managed MAC.
Allocates Rogue ID = 104 for an AP whose UIC is invalid and
its SSID is hidden among the APs that use a managed MAC.
Allocates Rogue ID = 105 for an AP whose UIC is invalid and
its channel is not in the channel validation list among the APs
that use a managed MAC.
Allocates Rogue ID = 106 if an AP uses a channel that is not
in the channel validation list among detected APs.
Allocates Rogue ID = 107 for an AP that uses a SSID that is
not in the ssid-whitelist among the APs that use a managed
MAC and its UIC is valid.
Allocates Rogue ID = 108 by checking the association status
CHAPTER 8. Security
Description
Description
page 290 of 496