Wlan-Based Acl Configuration - Samsung WEC8500 Operation Manual

2600-00FK1RGA4 Ver.
8) Select the tunnel mode.

tunnel-mode [TUNNEL_MODE]
Parameter
TUNNEL_
MODE
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<WLANs> menu in the sub-menus. For more information about configuration, see '5.1
Basic WLAN Configuration'.
5.1.3

WLAN-based ACL Configuration

To configure ACL to apply to the WLAN service, define IP-based ACL first and then
configure it to the WLAN.
Configuration using CLI
The procedures for configuration are as follows.
1) Before applying ACL, retrieve ACL that is configured as WLAN ACL.
WEC8500# show running-config network
fqm-mode
...
ip access-group wireless acl1
!
2) Go to configure  wlan configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# wlan 1
WEC8500/configure/wlan 1
WEC8500# configure terminal
WEC8500/configure# wlan 1
WEC8500/configure/wlan 1
3) Among retrieved ACLs, enter an ACL name to apply to the WLAN with the 'acl'
command.

acl [ACL-NAME]
4) To check the configured ACL, use the 'show wlan detail' command.
© SAMSUNG Electronics Co., Ltd.
3.0
- LocalBridging: Make all the user traffics are bridged at the AP.
- 8023Tunnel: Make all the user traffics are transmitted in the 802.3 format (Not
supported if the MAC type is split mac).
CHAPTER 5. WLAN Management
Description
page 168 of 496