2600-00FK1RGA4
Ver.
7.4.3
DCS Configuration
Describes the setting options of the DCS function which automatically sets the channel of
the AP.
Configuration using CLI
1) Go to configure rrm configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# rrm
2) Go to the wireless section where you want to change the settings.
WEC8500/configure/rrm# 80211a
3) Set the DCS function. Enter the dcs setting mode and set it to 'enable'. Use the 'no'
parameter to disable the mode. The function operates only when the RRM is set to
Enable.
WEC8500/configure/rrm/80211a# dcs
WEC8500/configure/rrm/80211a/dcs# enable
4) Execute the following command to change the execution interval. The default value is
120 (seconds).
WEC8500/configure/rrm/80211a/dcs# periodic-interval [value]
5) Execute the following command to change the Channel Utilization threshold.
The default value is 80 (%).
WEC8500/configure/rrm/80211a/dcs# channel-utilization-threshold [value]
6) Execute the following command to change the My Utilization threshold.
The default is 10 (%) for 80211a and 40 (%) for 80211b.
WEC8500/configure/rrm/80211a/dcs# my-utilization-threshold [value]
7) Execute the following command to set the anchor time. The default value is start time
4, end time 5. If both start time and end time are set to the same time, Anchor Run
function is disabled.
WEC8500/configure/rrm/80211a/dcs# anchor-time start [value] end [value]
© SAMSUNG Electronics Co., Ltd.
3.0
CHAPTER 7. WLAN Additional Services
page 239 of 496