Figure 57. Ap Retrieving Window - Samsung WEC8500 Operation Manual

2600-00FK1RGA4 Ver.
Parameter
PUBLIC_IP_ADD
RESS
PUBLIC_PORT
FALLBACK
START-END
TIME
INTERVAL
2) In the menu bar of <WEC Main window>, select <Configuration> and then select
the <Access Points> menu in the sub-menus. Click the name of AP Profile to which
the redundancy function will be applied. After configuring the DISCOVERY TYPE of
AP to 'APC Referal', select the PRIMARY CONTROLLER NAME, SECONDARY
CONTROLLER NAME, and TERTIARY CONTROLLER NAME. For the WEC8500
model, the TERTIARY CONTROLLER NAME is not shown in the menu.
© SAMSUNG Electronics Co., Ltd.
3.0
CAPWAP protocol. It is recommended not to use a different port number if it is
specially required.
PUBLIC IP address of the APC to add
This address is an IP required by an AP to connect to the APC. If the APC is in
the NAT environment, you must enter an official IP configured in the NAT
instead of the private IP of APC.
PUBLIC CAPWAP PORT number of the APC to add
This port number is required by an AP to connect to the APC. If the APC is
under the NAT environment, you must enter the port number configured in the
NAT instead of the actual CAPWAP port number of APC.
Enter the time zone where an AP connected to the backup (secondary or
tertiary) APC can do fallback.
The input format is as follows:
Format: hh:mm-hh:mm
Example: 2:00-5:00  Fallback is available between 2pm and 5pm.
Configures the interval that an AP connected to the backup (secondary or
tertiary) APC attempts fallback (second).
If a specific time is not entered, the default is 120 seconds.
The minimum is 60 seconds and the maximum is 1800 seconds.

Figure 57. AP retrieving window

CHAPTER 4. AP Connection Management
Description
page 136 of 496