Figure 135. Monitored List Window To Manually Change Wids Classification - Samsung WEC8500 Operation Manual

2600-00FK1RGA4 Ver.
8.2.2.3 Manual configuration (Move)
A user can change the classification of an unauthorized AP that is detected by the WIDS or
that is classified according to the rule configured by a user.
Configuration using CLI
1) Go to configure  wids  rogue configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# wids
WEC8500/configure/wids# rogue
WEC8500/configure/wids/rogue#
By using the MAC of an unauthorized AP to change, execute the move command.

move [MAC] [FROM] [TO]
Parameter
MAC
FROM
TO
2) To check the changed configuration, use the following command.

show wids rogue ap list unclassified

show wids rogue ap list friendly

show wids rogue ap list malicious
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Monitor> and then select the
<Rogues>  <AP> menu in the sub-menus. And when the AP list is displayed, select one
out of the AP list to go to the detail view screen. In the detail view screen, operator can
manually change the classification of an AP by using the top down menu of MOVE
CLASSIFICATION MANUALLY.
1) In the Rogue AP list screen, go to the detail view screen by clicking a MAC address.

Figure 135. Monitored List Window to Manually Change WIDS Classification

© SAMSUNG Electronics Co., Ltd.
3.0
MAC address of a detected AP
Previous classification of a MAC
Classification to change
CHAPTER 8. Security
Description
page 287 of 496