Vrrp Configuration - Samsung WEC8500 Operation Manual

2600-00FK1RGA4 Ver.
3.4.6

VRRP Configuration

The Virtual Router Redundancy Protocol (VRRP) is an Internet protocol that provides the
backup router operation method in a LAN. If a fault occurs with a router that transmits a
packet from a host in a LAN, decide a virtual IP address in a DHCP manually or by default
by using a virtual router fault recovery protocol and share it among routers. Once a primary
router and a backup router are decided, the backup router becomes a primary router when a
fault occurs with the primary router.
Configuration using CLI
To configure the VRRP related function, go to configure  router mode of CLI, enter a
router ID and interface name to go to the VRRP configuration mode.
WEC8500# configure terminal
WEC8500/configure# router
WEC8500/configure# router vrrp
WEC8500/configure# router vrrp 1 vlan1.10
WEC8500/configure/router/vrrp#
The following commands are provided.
[advertisement-interval]
Configures the advertisement interval of VRRP in second. A user can configure the interval
from 1 to 10.

advertisement-interval [INTERVAL]
Parameter
INTERVAL
[circuit-failover]
Enter an interface to configure and its priority.

circuit-failover [WORD] [PRIORITY]
Parameter
WORD
PRIORITY
[enable/disable]
Enables or disables the VRRP session.

enable

disable
© SAMSUNG Electronics Co., Ltd.
3.0
Interface name
Priority setup (range: 1-100)
CHAPTER 3. Data Network Function
Description
Advertisement interval (range: 1-10 s)
Description
page 102 of 496