Chapter 3. Data Network Function - Samsung WEC8500 Operation Manual

2600-00FK1RGA4 Ver.
CHAPTER 3.
In this chapter, how to set up the data network functions of APC including VLAN, link
aggregation, and layer 3 protocol is described.
3.1 Port Configuration
The APC port is configured with a physical interface.

Physical interface of 11 ports except WEC8500 console port

Physical interface of 4 ports except WEC8050 console port
3.1.1 Port management
The WEC8500 Management port is used to manage the WEC8500. It does not
support VLAN and its interface name is 'mgmt0'. The 8 ports at the right side of
Management port are 10/100/1000 BASE T-ports and their names are GE1-8.
To the right side of the 10/100/1000 BASE T-ports, there are two Gigabit ports, i.e.
XE1 and XE2.
Configuration using CLI
To configure the port related function, enter into the interface mode by entering the
'interface [INTERFACE_NAME]' command in the configure mode.
An example of entering into the interface setup mode of the management port is shown
below.
WEC8500# configure terminal
WEC8500/configure# interface mgmt0
WEC8500/configure/interface mgmt0#
© SAMSUNG Electronics Co., Ltd.
3.0
Data Network Function

CHAPTER 3. Data Network Function

page 43 of 496