Figure 116. Dcs Settings - Samsung WEC8500 Operation Manual

2600-00FK1RGA4 Ver.
8) Execute the following command to change the channels that is automatically set by the
DCS. Use the 'no' parameter to disable the mode.
WEC8500/configure/rrm/80211a/dcs# channel [value]
9) Execute the following command to use the Delayed Channel Change function.
To disable the configuration, enter the 'no' parameter. The default is Disable. The
Delayed Channel Change function delays channel change instead of changing it
immediately when a channel becomes busy due to channel utilization. If the anchor
time is not configured, the default value is used at 4 o'clock.
WEC8500/configure/rrm/80211a/dcs# delayed-channel-change
10) To use the Aware Option function, execute the following command. To disable the
configuration, enter the 'no' parameter. The Aware Option does not change a channel if
there is a specific condition. Therefore, three functions are provided based on whether
there is a voice, the association of a station, or traffic in a station. The default is that
only the Voice Aware function is enabled. The Station Aware function specifies the
number of stations at the same time.
WEC8500/configure/rrm/80211a/dcs# aware-option voice
WEC8500/configure/rrm/80211a/dcs# aware-option station [station count]
WEC8500/configure/rrm/80211a/dcs# aware-option traffic
11) Check the settings using the 'show rrm config-summary' command.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Radio>  <802.11a/n> or <802.11b/g/n>  <RRM> menu in the sub-menus.
Enable or disable the DCS in the SERVICE field in Dynamic Channel Selection.
© SAMSUNG Electronics Co., Ltd.
3.0

Figure 116. DCS settings

CHAPTER 7. WLAN Additional Services
page 240 of 496