Detecting Wlan-Based Communication Failure - Samsung WEC8500 Operation Manual

Access point controller

Hide thumbs Also See for WEC8500:

Table of Contents

2600-00FK1RGA4

7.11.2 Detecting WLAN-based Communication Failure

You can configure whether to detect WLAN-based communication failure.

Configuration using CLI

1) Go to configure mode of CLI.

APC# configure terminal

APC/configure#

2) Enable or disable communication failure detection.

[no] call-fail-detect [WLAN_ID]

3) To check the configured connection limitation information, use the 'show voip config

[WLAN_ID]' command.

Configuration using Web UI

In the menu bar of <WEC Main window>, select <Configuration> and then select the

<WLANs> menu in the sub-menus. Select a WLAN ID to change in the WLANs screen

and go to the <Advanced> tab.

After configuring the VOIP FAILURE DETECT item, click the <Apply> button.

Figure 125. Detecting WLAN-based communication failure

CHAPTER 7. WLAN Additional Services

WLAN ID (range: 1-240)

page 265 of 496

Table of Contents